floating suction strainer
Swimming freely the head of the suction strainer will sink about 15cm deep
into the water and suck in the middle, mostly clean layer of water.
Mud and sand from the ground and flotsam from the surface area will not
be able to reach the suction strainer.
Fire protection pond: The mud layer at the bottom of the pond will not be
churned up in order to avoid continuous clogging of the suction head.
Because of its large suction strainer it is also possible to use the S50
on or between water plants.
Rivulets: Using this model will allow you to get water out of the smallest
watercourses. On a gravelly ground only a few centimetres of water
depth will be enough. Building time-expensive dams or digging holes will no
longer be necessary.
Pumping out cellars: Big amounts of water can be handled quickly down
to only a few centimetres.
The floating body is made of indestructible Polyethylen,
the strainer of A2-stainless steel perforated plate.
Developed and produced in St. Pankraz, Austria
Floating suction strainer S50
7kg measurements: 570x380x200 mm
connection standard: Storz A 110mm coupling
also available with any other coupling between 100mm and 125mm
Floating suction strainer S20
3kg measurements: 410x260x190 mm
Connection: Storz B 75mm, Storz C 52mm